What are the requirements when using fully enclosed e-chain?

Industrial fully enclosed cable chain are generally used on cables, oil pipes, bronchus, tap water pipes, and ventilation ducts such as CNC lathe machinery and equipment, and have the effect of traction belt protection and protection. According to the environment used and the application standard, it can be divided into three types: flat arm towline, fully enclosed towline and semi-enclosed towline. In addition, each section of the fully enclosed cable chain can be opened, which is convenient for installation and maintenance. Low noise, wear resistance and fast movement during exercise.

Totally enclosed cable chain have gradually been widely used, but they need to meet certain regulations, so only in this way can the efficiency be continuously improved. So what is the demand for fully enclosed cable chain?

For this problem, the plastic manufacturer of fully enclosed cable chain below will briefly introduce it to you.

1. The fully enclosed cable chain laying cables must not be distorted. It is not the cable from one end of the cable drum or the cable bridge to a certain end. Instead, the coil drum or cable must be rotated first. Cable reels, to carry or suspend cables as necessary. The cable application places are only obtained directly on the cable electromagnetic coil.

2. Pay attention to the small bending radius of the cable.

3. The cables in the cable chain cannot touch each other.

4. The two points of the fully enclosed cable chain should be fixed, or fixed at the moving end of the cable chain. The moving point should be 20-30 times away from the cable diameter of the cable chain node.

5. If the transmission chain is broken, the cable must be replaced, because the rupture caused by excessive stretching is inevitable.

6. The cables should be placed neatly in the tow chain, and the layout should be separated as much as possible. The difference between them shall be at least 10% of the cable diameter.

7. It is necessary to ensure that the fully enclosed cable chain products can move sufficiently within the bending radius, that is, they cannot be forced to move. In this way, the center of the cable can move relatively. In addition, after a period of operation, the cable position can be inspected, and this inspection must be carried out after the sliding door is moved.